Safety

Occupational health and safety (OHS) policies exist to ensure safe working conditions. Seven Electrical Communications Pty Ltd. can ensure your building is compliant to the latest OHS standardswith:

Installation and maintenance of emergency and exit lighting to ensure compliance with the building code of practice Australia i.e. sufficient lighting to illuminate emergency exit paths of a building and ensuring existing emergency lighting pass battery tests.

Ensuring compliance with safety switch regulations i.e. all single phase and three phase circuits that are under 20amps require a safety switch to be installed.

Safety in the home

It’s easy to use electricity safely at home if you understand the risks and take care. Our tips can be a helpful start.
-Retire, replace or have repaired damaged electrical appliances (i.e. damaged/frayed cords; cracked housing; broken plugs).
-Ensure you have and RCD Safety Switch installed and test regularly.

-Turn off power points before plugging/unplugging appliances.
-Turn off all appliances such as air conditioners, heaters, ovens and stove tops when leaving your home.
-Maintain exhaust fans in a clean condition, free of lint.
-Ensure appliances have adequate breathing space to prevent overheating.
-Remove all combustible material situated near stoves, heaters and lamps.
-Licensed electricians should undertake all your electrical work and repairs.
-Be extremely careful when using appliances connected to power points near wet areas including sinks, baths and swimming pools
.
-If an electrical appliance has been immersed in water it must be discarded immediately.
-Don’t use portable heaters in bathroom areas. Instead, you should have either a strip heater installed high on the wall or a ceiling unit installed by a registered electrical contractor.
-Never touch anything electrical with wet hands or bare feet.
-Switch off and unplug your toaster before trying to remove toast, muffins or crumpets that are caught in the body of the unit
.
-Safely remove bread crumbs from the toaster regularly as a build up can be hazardous.
-Never leave cooking unattended. If you must leave the room momentarily take something with you as a reminder that you are cooking (eg. a wooden spoon)
-Extension cords with damaged plugs or cords should be discarded.
-Extension cords should have 3 pins (plugs with 2 pins are not earthed and should be used only with double insulated electrical equipment).
-Be familiar with where your switchboard is located.
-Label switches, circuit breakers or fuses.

 

Testing and Tagging

The benefits when hiring our qualified electricians to test and tag your electrical appliances include experienced 3 phase testing and single phase testing, electrical repairs to defect appliances and licensed to test and tag construction and building sites.Seven Electrical & Communications Pty Ltd  testing and tagging service, provide a full range of  testing and taggingto businesses of all sizes, from all consumers, & self-employed persons with only a hand full of appliances though to large multi-site organisations with thousands of electrical items to inspect and test including –

 Office testing & tagging.

Electrical Safety Inspections.

 Schools & Businesses Test And Tagging.

Surge Protection Install.

Safety Switch Testing & Installation.

Test & Tag Commercial Businesses.

Emergency & Exit Lighting Testing.

All our qualified electricians perform testing and tagging services that are fully compliant with AS/NZS 3760 in-service safety inspection and includes tests such as polarity testing, insulation resistance test, current leakage and earth resistance tests that comply to Australian Standards.

 

Contact Form

captcha